Wednesday, May 12, 2010

How to Thread a Sewing Machine

Threading a sewing machine can be difficult at first. Once you learn how, though, the whole process will take you only a few seconds and you'll be on your way sewing together anything you need. It does require somewhat of a good eye sight and good aim, so get your glasses if you need them to see up close.


Instructions



  1. Step1
    Raise the needle to its highest position by turning the handwheel toward you.
  2. Step2
    Raise the presser foot. This will allow the thread to easily pass through the threading points and will prevent the machine needle from becoming unthreaded when you begin to stitch.
  3. Step3
    Place a spool of thread on the spool pin located at the top of your sewing machine. If the spool pin runs horizontally, secure the spool of thread with the cap provided.
  4. Step4
    Take hold of the thread end and pass it through the designated threading points on the top of the machine casing, then down toward the tension assembly. The tension assembly is located on the left side of the machine and controls the flow of thread.
  5. Step5
    Take the thread under the tension assembly and back up through the next threading point at the top left of the machine. Make sure the thread has passed between two tension discs as well as the hook that may be attached to the left side of the tension dial.
  6. Step6
    Push the thread end through the lever at the top left of the machine, if applicable, and down through the threading points at bottom left and above the needle.
  7. Step7
    Thread the needle from the front or back of the needle. The threading direction will depend on your machine type.
  8. Step8
    Pull a few inches of thread through the eye of the needle and pull the thread to your left.
  9. Step9
    Insert a wound bobbin into the machine, if necessary, and close the throat plate. A few inches of bobbin thread should be pulled out to the right and sticking out from under the closed throat plate.
  10. Step10
    Take hold of the thread that has been threaded through the machine needle.
  11. Step11
    Rotate the hand wheel toward you until the needle disappears into the bobbin case.
  12. Step12
    Keep holding on to the thread and move the hand wheel so the needle is once again at its highest position. As the needle rises, a loop of bobbin thread will come up as well.
  13. Step13
    Pull the thread out toward your left to draw the bobbin thread loop further out of the bobbin case.
  14. Step14
    Let the top thread go and pull the bobbin thread up until the end comes up. Pull the top and bottom threads under the presser foot and to the back and right of the machine.

0 comments:

Post a Comment

Condominium Projects

Download MP3 Center

Home Refinancing

phoenix dui

free counters

Modified by Blogger Tutorial

wire drawing machine ©Template Nice Blue. Modified by Indian Monsters. Original created by http://ourblogtemplates.com

TOP